Direct Out Switch
When depressed,
allows signal to pass to the di-
rect out jack on the back of the input rnodule.
Push to lock, push again to release.
Direct Out Jack
Provides an unmixed single signal output of
what-
ever has been assigned to the module. This direct
output
can be used for a variety of purpose, such
as:
1.
A subsidiary mix can be made by using an ac-
cessory mixer fed by this output.
2.
One-rnic, one-track recording happens fre-
quently, and using DI RECT OUT will pass un-
needed
sumrning networks and amplifiers. Go-
ing "Direct" to the recorder will result in a
cleaner signal.
Channel Assign and Pan Pot
On the M-35 rnonitoring will be possible by
switching the appropriate monitor section to
"TAPE" and listening to the recorder instead of
a buss rnaster. For metering, either the recorder
or an accessory meter bridge (MB-20)
can be used.
Since the amplifier that feeds this jack also feeds
the buss-assign network and the post fader effects
system
it is wise to calculate the total load care-
fully. The
output load impedance of this jack
is
10k ohrns. The load of the pre-wired circuits re-
strict the connection of this output to a single
circuit at a
time, unless the equipment you plan
on connecting here
is
known to have
a
very high
values for input irnpedance
(100
k
ohms or more).
8
track monitor
Stereo monitor
no monitor yet, so
monitor playback
out electronics with
M-35
switchable buss/tape monitor
To Next Page
