2.
In this second model, one patch point uses
cess-send to one, then pass through the second,
"pass through" again, and signal-by-signal
is
and then back to access-rcv. Since each in-
patched through the accessory send-rcv point put load
is
22
k ohms, the actual load on the
on each input module. You now
have a pre- accessory send
is
1
l
k and
is
safe. We don't re-
fader, pre-equalizer stereo cue mix in addition commend more than two here. At this point
to the "mono" that
is
built-in. you get anything assigned to the module;
Need two? Cascade a pair this way, from ac- "Tape tracks", "Line ins" and "Mic ins"as well.
3.
If you need an effects-send that contains the "assigned" by using the direct-out button on
results of input faderadjustment and equaliza-
the module and will also follow fader action.
tion, use the direct-out source shown in
exam-
Two units may be cascaded as in the previous
ple
#3.
Now your "mix" can be "muted" or
example if necessary.
3
Recommended Locations for Model
1
1
in tape return
to
Taoe
in"
To Next Page
