GTS Technical Manual
19. April 2010 Edition: V1.00/2010 5-32
Copyright © 2010, Diversey Inc.
05.0 swingo 1255 B Power - mechanics.fm
brush belt.
• Position the fixation screw and tighten the center screw of the
clamping piece.
Adjustment
Turn the coupling hubs (07/128) by hand in opposite direction to
ensure that the belt is correctly mounted and stays in the middle of
the pulley.
• Mount the bracket (07/146), position the screws of the buffer
and tighten them.
• Position the protective cover onto the brush unit.
• Position and tighten the five screws of the protective cover.
Ensure that the brush belt does not touch the cover.
• Position the decoupling bow.
• Mount the tension springs of the decoupling bow.
• Complete assembling according to chapter REPLACING OF
BRUSH DRIVE UNIT.
To Next Page
Loading...
