Taylor 340 User Manual

3-2
SAFETY
Models 340, 341, 342
Safety
3
the proper cord anchorage to relieve conductors
from strain, including twisting, at the terminals
and protect the insulation of the conductors from
abrasion.
• If the supply cord is damaged, it must be
replaced by an authorized Taylor service
technician in order to avoid a hazard.
• Secure the supply cord ground lead to the
machine in a location where if the cord is pulled,
the main power leads will become taut before
the ground lead can break loose.
Failure to follow these instructions may result in
electrocution. Contact your local authorized Taylor
distributor for service.
WARNING! This machine must NOT be installed
in an area where a water jet or hose can be used.
NEVER use a water jet or hose to rinse or clean the
machine. Failure to follow this instruction may result in
electrocution.
WARNING! Only install this machine in a
location where its use and maintenance is restricted to
trained personnel. Failure to comply may result in
personal injury.
WARNING! Avoid injury.
• DO NOT allow untrained personnel to operate
this machine.
• DO NOT operate the machine unless all service
panels and access doors are restrained with
screws.
• DO NOT remove any internal operating parts
(including, but not limited to, the freezer door,
beater, or scraper blades), unless all control
switches are in the OFF position.
Failure to follow these instructions may result in severe
personal injury, especially to fingers or hands, from
hazardous moving parts.
WARNING! This machine has many sharp
edges that can cause severe injuries.
• DO NOT put objects or fingers in the door
spout. This may contaminate the product and
cause severe personal injury from blade
contact.
• USE EXTREME CAUTION when removing the
beater assembly. The scraper blades are very
sharp.
CAUTION! This machine must be placed on a
level surface. Extreme care should be taken when
moving machine for any reason. Two or more persons
are required to safely move this machine. Failure to
comply may result in personal injury or damage to the
machine.
IMPORTANT! Access to the service area of
the machine must be restricted to persons having
knowledge and practical experience with the machine, in
particular as far as safety and hygiene are concerned.
NOTICE! Cleaning and sanitizing schedules
are governed by your federal, state, or local regulatory
agencies and must be followed accordingly. Please refer
to the cleaning section of this manual for the proper
procedure to clean this machine.
CAUTION! This machine is equipped with a
refrigerated cabinet, designed to maintain product
temperature at or below 40°F (4.4°C). Before
replenishing the mix supply, the product must be
refrigerated at or below 40°F (4.4°C). Failure to follow
this instruction may result in health hazards and poor
freezer performance.
DO NOT run the machine without product. Failure to
follow this instruction can result in damage to the
!
!
!
!

Taylor 340 Specifications

General

Brand	Taylor
Model	340
Category	Freezer
Language	English