OPERATING PROCEDURE
6-3
Models 340, 341, 342
Operating Procedure
6
Freezer Door Assembly Standard
Door
(No Prime Plug)
Note: Model 342 comes equipped with two door
options: a standard door without a prime plug or a self-
closing door with a prime plug. Follow the appropriate
assembly procedures for your style door. (To assemble
Model 342 self-closing door with prime plug, go to
page 6-5 and perform Steps 1 to19).
1. To assemble the door with the ice buster (door spout
clearing device), install the O-rings on the draw valve
and lubricate.
Figure 6-7
2. Insert the draw valve into the door, leaving
approximately 1/2 of the valve sticking out the top of
the door.
Figure 6-8
3. Rotate the draw valve so the flats on the top of the
draw valve are perpendicular to the door face.
Figure 6-9
4. Insert the ice buster through the door spout and into
the slot located just above the lower O-ring.
Figure 6-10
5. With the ice buster in place, rotate the draw valve to
allow installation of the draw handle. This will lock the
ice buster in place. Install the draw handle pin, and
close the draw valve by moving the handle to the left.
Figure 6-11
11019
Apply the appropriate
Taylor approved food safe lubricant.
To Next Page
Loading...
