7-2
OPERATOR CHECKLIST
Models 340, 341, 342
Operator Checklist
7
instruction may result in personal injury or death from
electrical shock or hazardous moving parts, as well as
poor performance or damage to the machine.
On water-cooled machines, check the water lines
for kinks or leaks. Kinks can occur when the
machine is moved back and forth for cleaning or
maintenance purposes. Deteriorated or cracked
water lines should be replaced only by an
authorized Taylor mechanic
Winter Storage
If the place of business is to be closed during the winter
months, it is important to protect the freezer by following
certain precautions, particularly if the building is subject
to freezing conditions.
Disconnect the freezer from the main power source to
prevent possible electrical damage.
On water- cooled freezers, disconnect the water supply.
Relieve pressure on the spring in the water valve. Use
air pressure on the outlet side to blow out any water
remaining in the condenser. This is
extremely
important. Failure to follow this procedure may cause
severe and costly damage to the refrigeration system.
Your local Taylor distributor can perform this service for
you.
Wrap detachable parts of the freezer (such as beater,
blades, drive shaft, and freezer door) and place in a
protected dry place. Rubber trim parts and gaskets can
be protected by wrapping them with moisture-proof
paper. All parts should be thoroughly cleaned of dried
mix or lubrication, which can attract mice and other
vermin.
To Next Page
Loading...
