8-2
TROUBLESHOOTING GUIDE
Models 60 and 62
Troubleshooting Guide
8
4. Large pressure
adjustments are
necessary to receive
1 oz. (29.6 ml.) in
6 seconds.
a. Hardened syrup in syrup line. a. Sanitize syrup lines once a week. 6-14
b. Syrup line and air line not matched
properly to syrup tank.
b. Match syrup and air lines to syrup
tank.
6-9
5. The mix hopper is too
warm.
a. Product too warm when placed in
hopper.
a. Check temperature in storage cooler.
7-1
b. Control switch in the OFF position. b. Place in AUTO position. 6-8
c. The temperature is out of
adjustment.
c. Call a service technician to adjust
hopper temperature.
- - -
6. The mix hopper is too
cold.
a. The temperature is out of
adjustment.
a. Call a service technician to adjust
hopper temperature.
- - -
7. Machine short cycling
(rapid on and off cycles).
b. Dirty air-cooled condenser. b. Brush-clean every 30 days. 7-2
c. Inadequate water supply on
water-cooled unit.
c. Check water supply.
1-2
d. Defective condenser fan. d. Call service to repair or replace. - - -
e. No airspace surrounding machine. e. Maintain specified air clearance. 1-1
8. The freezing cylinder
walls are scored.
a. The scraper blades are damaged. a. Replace the scraper blades. 6-2
b. Machine was placed in AUTO
before all sanitizing solution was
removed from freezing cylinder.
b. Place machine in AUTO only after
priming is complete and all sanitizing
solution is removed.
6-7
c. The front bearing is missing or
worn on the freezer door.
c. Install or replace the front bearing.
6-4
d. The beater assembly is bent. d. Call a service technician to repair or
replace beater and to correct cause of
insufficient mix in freezing cylinder.
- - -
e. The beater pins are broken. e. Call service technician to repair or
replace.
- - -
9. The driveshaft is stuck in
the gearbox coupling.
a. Lubrication on hex end of shaft. a. Call service techician for removal. - - -
b. Rounded corners of hex end of
driveshaft.
b. Replace defective driveshaft.
- - -
a. Rounded corners of coupling on
gearbox.
a. Call service technician to replace
gearbox.
- - -
10.Excessive mix leakage
into the rear drip pan.
a. Worn or missing seal on driveshaft. a. Replace every 3 months. 9-1
b. Inadequate lubrication of
driveshaft.
b. Follow lubrication procedures in
Assembly on page 6-1.
6-2
c. Bad rear shell bearing. c. Call service technician to replace rear
shell bearing.
- - -
d. Driveshaft and beater working
forward.
d. Call service technician.
- - -
Problem Probable Cause Remedy
Page
Ref.
To Next Page
Loading...
