Taylor 62 - Troubleshooting: Machine Not Operating in AUTO

TROUBLESHOOTING GUIDE
8-3
Models 60 and 62
Troubleshooting Guide
8
11.Machine will not operate
when control switch is in
the AUTO position.
a. Draw arm not raised. a. Raise draw arm momentarily to
activate system.
6-8
b. Circuit breaker off or blown fuse. b. Turn circuit breaker on or replace
fuse.
- - -
c. Beater motor out on reset. c. Clear the tone and reset freezer. 5-2
d. Water turned off (water-cooled
machines).
d. Re-establish water supply.
1-2
a. Machine unplugged. a. Plug into wall receptacle. - - -
12.Water continues to flow
through spinner
housing.
a. Rinse solenoid stuck open. a. Call service technician for repair.
- - -
13.Lift motor continues to
raise draw valve after
draw of product has
been made.
a. Micro switch needs adjustment. a. Call service technician for repair.
- - -
14.Air compressor runs too
often for normal usage.
a. Air leak in system. a. Use a soap solution to locate the leak.
- - -
15.Spinner shaft will not
rotate to blend syrup into
product.
a. Flexible cable broken. a. Call service technician to replace
cable.
- - -
b. Pin missing in female quick
disconnect.
b. Call service technician to replace
disconnect.
- - -
a. Spinner motor out on thermal
overload.
a. Inadequate lubrication of spinner
shaft. Lubricate entire length of shaft.
6-5
16.Excessive drippage of
product from spinner
housing.
a. The draw valve O-rings are worn or
missing.
a. Replace every 3 months.
9-1
b. Wrong O-rings on draw valve. b. Check O-ring size. - - -
c. Inadequate lubrication of spinner
shaft.
c. Follow lubrication procedures in
Assembly.
6-5
Problem Probable Cause Remedy
Page
Ref.