How to remove a stuck drive shaft from the drive coupling in my Taylor Ice Cream Maker?
If the drive shaft is stuck in the drive coupling, it could be due to mix and lubricant accumulation; regularly brush clean the rear shell bearing area. Rounded corners on the drive shaft or coupling can also cause this, so replace worn components. Finally, a misaligned gear box can be the culprit; re-align it.
What causes scored freezing cylinder walls in my Taylor 8751 Ice Cream Maker?
Scored freezing cylinder walls can be caused by a missing or worn front bearing; install or replace it. Broken beater pins (pump style freezers only) can also cause this, so replace the beater assembly, ensuring scraper blades are properly attached over the pins. A bent beater assembly should be replaced. Finally, a misaligned gear box can contribute; re-align it.
Why is product collecting on top of the freezer door of my Taylor Ice Cream Maker?
If product is collecting on top of the freezer door, the top o-ring on the draw valve might be improperly lubricated or worn; lubricate it properly or replace the o-ring.
What to do if the pump won't operate in PUMP mode on my Taylor 8751?
If the pump won't operate in PUMP mode, try pushing the reset button. If that doesn't work, the membrane switch may be defective and need replacement.
Why are the MIX LOW and MIX OUT probes not working on my Taylor Ice Cream Maker?
If the MIX LOW and MIX OUT probes aren't functioning, there might be milkstone build-up in the hopper. Clean the hoppers thoroughly.
What to do if my Taylor 8751 Ice Cream Maker is not dispensing product?
If your Taylor Ice Cream Maker isn't dispensing product, several factors could be at play. First, ensure the mix hopper isn't low; if the MIX OUT light is on, add mix. Next, verify the power switch is in the ON position and press the AUTO keypad. If the beater motor is out on reset, allow it to cool, turn the power switch OFF, press the reset button, turn the power switch ON, and press the WASH keypad, checking that the drive shaft turns CLOCKWISE. Then press the AUTO keypad. Also, check the air/mix pump assembly, ensuring it's correctly assembled and properly lubricated. Confirm the spring and poppet are correctly installed on the mix inlet fitting, replacing if necessary. If the mix pump ball crank is broken, replace it. Ensure the pump motor is activated by pushing the reset button and ...
Step-by-step guide on adjusting the viscosity control.
Explains mix temperature settings for cabinet and hopper.
Guide on setting the mix cabinet temperature.
Steps for setting standby temperatures.
Basic checks before troubleshooting control boards.
Explains the self-test program for diagnosing control issues.
Details the second part of the self-test program for potentiometers.
Lists probable causes and remedies for no product dispensing.
Lists probable causes and remedies for thick product.
Lists probable causes and remedies for soft product.
Lists probable causes and remedies for warm hopper mix.
Lists probable causes and remedies for cold hopper mix.
Lists probable causes and remedies for pump failure in PUMP mode.
Lists probable causes and remedies for unit not running in AUTO mode.
Lists probable causes and remedies for feeding issues.
Lists probable causes and remedies for probe malfunction.
Probable causes and remedies for pump failure on PUMP press.
Probable causes and remedies for pump failure in AUTO mode.
Probable causes and remedies for pump piston issues.
General| Brand | Taylor |
|---|---|
| Model | 8751 |
| Category | Ice Cream Maker |
| Language | English |
To Next Page
