Taylor C845 User Manual

75
McDonald's Intelligap Grills
Troubleshooting
160122
All Models (Cont'd.)
PROBLEM PROBABLE CAUSE REMEDY
The display reads “TOO COOL”
(Zone ID) and will not allow a cook
cycle to start.
This error message displays when
a zone drops 39 degrees below set
point.
Loose frozen product (e.g., onions,
shrimp) is being piled on top of the
thermocouples. This can drop the
plate temperature around the
thermocouple, causing a fault.
Inspect operation and inform the
operator to spread the product to a
uniform thickness. Avoid laying
product directly over the center of
the cook zone (where the
thermocouples are positioned).
Frozen whole muscle product
(chicken breast) may cause this
fault if too many are placed on the
grill or directly over the
thermocouples.
Inspect operation and inform the
operator to reduce the number of
products being laid. Show the
operator how to properly place
product, avoiding placement of
product directly over the
thermocouples.
The exhaust hood and grill will not
turn on when fan interlock switch is
placed in the ON position.
The restaurant circuit breaker has
been tripped.
Reset the circuit breaker.
The fan disconnect switch on the
roof is in the OFF position.
Place the switch in the ON
position.
The fan interlock cord is not
connected properly.
Reconnect the cord.
The fan interlock switch is faulty. Replace the fan interlock switch.
The exhaust hood alone does not
turn on when the fan interlock
switch is in the ON position.
The fan interlock switch is faulty. Replace the fan interlock switch.
Loose or broken wires. Locate, repair or replace wires.
The grill alone will not turn on
when the fan interlock switch is in
the ON position.
The fuse in the control box is
faulty.
Replace the fuse.
The fan interlock switch is faulty. Replace the switch.
The ansul reset tripped. Press the ansul reset button.
The upper platen will not stay in
the COOK or STANDBY position.
The processor control is faulty. Replace the processor control.
The control harness is faulty. Replace the control harness.
Temperature is insufficient to
satisfy the indicator LED's.
Wait until the indicator LED's turn
green.
The interface board is faulty. Replace the interface board.
The latch switch is faulty. Replace the latch switch.
The latch solenoid is faulty. Replace the latch solenoid.
The pneumatic system is faulty. Find the leak and repair.

Taylor C845 Specifications

General

Brand	Taylor
Model	C845
Category	Grill
Language	English