Taylor Horizon 8752 - Page 34

6-8
OPERATING PROCEDURES
Models 8752 and 8756 with Horizon® Pump
Operating Procedures
6
15. Secure the pressure relief assembly by installing the
retaining pin into the rear retaining pin plate.
Figure 6-31
Note: The assembled parts must align with the
matching hole in the mounting plate.
16. Attach one end of the flare line to the pressure relief
valve outlet fitting of the Horizon
®
pump. Attach the
other end to the mix feed tube.
Figure 6-32
17. Install the pressure line. Attach the quick disconnect
fitting of the pressure line to the other fitting on the
mix inlet tube, just above the flare line. Allow the
other end to hang free.
Figure 6-33
18. Assemble the mix suction line. Attach the weighted
end to one opening of the suction tube.
Figure 6-34
15180
15171
15172
15081