15
Model 390 Tim Hortons Operating Procedures
110503
Step 10
Rotate the draw valve so the flats on the top of the
draw valve are perpendicular to the door face.
Figure 12
Step 11
Insert the ice buster through the door spout and into
the slot located just above the lower o-ring.
Figure 13
Step 12
With the ice buster in place, rotate the draw valve to
allow installation of the draw handle. This will lock
the ice buster in place. Install the draw handle pin,
and close the draw valve by moving the handle to
the left.
Figure 14
Step 13
Place the o-ring onto the prime plug and lubricate.
Figure 15
Step 14
Screw the prime plug into position on the front of the
door.
Figure 16
To Next Page
Loading...
