PROGRAMMING
CHANGING PROGRAMMING CODE
IMPORTANT: The factory preset Programming Code is 1-2-3-4-5-6 and
needs to be changed to a unique 6 digit number before
operating the deadbolt.
1. Press (SET) button for 2 seconds until the Red LED lights up and
a “beep” sounds twice. You are now in the programming mode.
2. Enter 1-2-3-4-5-6 (or current Programming Code) and press the
button.
3. Enter [ 10 ] and press the button.
4. Enter a new unique 6 digit Programming Code and press the
button. The Red LED light will remain on for 10 seconds in case any
further changes need to be made.
23
® REGISTERED TRADEMARK OF TAYMOR INDUSTRIES LTD.
To Next Page
Loading...