TROUBLESHOOTING GUIDE - INSTALLATION
QUESTIONS ANSWERS
A. The lockset
did not operate
correctly after
installation.
1. Make sure that AUTOMATIC BOLT DIRECTION
ADJUSTMENT procedure was run properly
following installation. Refer to page 20.
2. Check the center of the strike hole for align-
ment with latch hole on the door to ensure
free movement of the latch bolt.
3. Make sure the torque blade is properly
inserted (in the horizontal position) in the
latch drive.
B. Feel a bump
while turning
the thumbturn
or the key.
1. Please execute lock & unlock function to
allow the motor to reposition itself.
35
® REGISTERED TRADEMARK OF TAYMOR INDUSTRIES LTD.
To Next Page
Loading...