25
® REGISTERED TRADEMARK OF TAYMOR INDUSTRIES LTD.
PROGRAMMING
ADD ONE OR MORE SINGLE-USE USER ENTRY CODES
IMPORTANT:
1. The single-use user entry code can be used for only one successful
entry and will be invalid when the lockset is locked again.
2. The auto-lock mode should be activated prior to the following steps
so the door is locked when the single-use user leaves the building.
3. Maximum single-use user entry code capacity is 5 user entry codes
(4 digits).
Follow these steps:
1. Press [SET] button for 2 seconds. The Red LED will light up and a
“beep” will sound twice. You are now in the programming mode.
2. Enter 1-2-3-4-5-6 (or current Programming Code) and press the
button. Enter [ 21 ], press the button, enter the Single-Use
User Entry Code (4 digits) and press the button. The Red LED will
light continuously for 10 seconds in case any further changes need to
be made.
To Next Page
Loading...