10
Quick Start
f a. Connections
1. Turn down your mixer channel or main PA
volume.
2. Connect a Mic or Line level input from the
mixer to the respective input jack on VoiceLive
Rack.
3. Connect the XLR or TRS stereo outputs to
your mixer/PA.
4. Connect the supplied AC adaptor to the unit
and press the POWER button in.
f b. Set input level
1. Touch the Bypass button so it ashes.
2. Touch the Input Gain button.
3. Sing or start playback while watching the IN
meter in the display
4. Adjust the IN GAIN setting with the knob
below the onscreen parameter until no CLIP
message occurs.
5. Touch Home to exit Input Gain setup.
f c. First audio
1. Select preset 6: BRIGHT DOUBLE with the
large wheel or the Navigate up/down arrows.
2. Sing or start dry vocal playback then raise your
monitors/PA level until you hear the VoiceLive
Rack output at a comfortable volume.
3. Touch the Bypass button to hear the effect
programmed into the current preset.
4. Now you can select different presets and/or
touch the effect blocks (µMod, Delay, Reverb
etc) to turn them on and off within the cur-
rent preset.
To Next Page
Loading...
Need help?
General