62
The Edit Button
The key that is set in the HARMONY tab will be
displayed but not editable when the current pre-
set is based on Scale Harmony and HARDTUNE
KEY is set to FOLLOW HARMONY
f NOTE & ENABLED
These are applicable when you wish to edit a
custom scale for HARDTUNE. A custom scale
is indicated by a series of dashes and circles: “-”
and “o”. Each of these symbols represents where
a note is in the correction scale or not. You can
change the custom map by selecting a note you
want to be corrected to or to jump over with
the NOTE parameter and setting its ON or OFF
status with the ENABLE parameter. You’ll see an
indication of your custom scale with “o” repre-
senting notes that are enabled, and “-” showing
notes that are disabled. For example “o-o-oo-o-o-
o” would represent a major scale in any key (the
octave up note is implied by the root note).
To Next Page
Loading...
Need help?
General