You can rename the preset and store to another
location by pressing Store once and changing the
values at the bottom of the Store menu. When
you’ve edited the name and found a new place to
store your edited preset, press Store again.
To cancel an incomplete Store operation from
within the Store tab, press Home or Edit.
Editing
Editing Overview
Basic editing, menu navigation and concepts are
briey discussed in the Quick Start and Basic Op-
eration sections. This Edit Menu section discusses
the actual parameters in detail for those that
want to go beyond merely loading a new style in
order to make changes to their sound.
Navigation
Press the Edit button or hold any individual effect
block button (e.g. Double) to access the editing
menus and make changes to the current preset.
This will present the edit tabs. Press the right and
left Navigate arrow buttons to cycle right and left
through the tabs shown at the top of the screen.
Each tab represents a front panel button with ad-
ditional tabs for Mic-control, Switch3 and overall
preset settings. Holding either arrow button
jumps from the uMod tab to the Preset tab.
Turn the Mix/Edit knobs to change the setting
of the parameter directly above that is within
the highlighted row. Up to 3 rows are visible per
screen with additional rows accessible by turning
the Data Wheel or using the Up/Down arrow
buttons. A vertical scroll bar at the right of the
screen shows where you currently are in the
menu.
To exit the Edit menu, press Home.
Saving Changes
You can quickly store at the current preset loca-
tion from within the Edit menu by pressing the
Store button twice. If you’re nished editing,
press Home to exit the Edit menu.
54
To Next Page
Loading...
Need help?
General