23
Tap Button Overview
This button provides convenient access to tempo
setting for the Delay and Rhythmic effects. You
can tap it at any time to synchronize these effect
blocks to the beats of a song.
The display will temporarily show the BPM (Beats
Per Minute) derived from your most recent two
taps.
To enter an exact BPM, you can use the up or
down Navigate buttons while the TEMPO display
is shown on the display for ne tuning.
The Delay or Rhythmic effect buttons must be
active for Tap tempo to have an audible effect.
Upon loading a new preset, the LED in the Tap
button will ash indicating the Delay SOURCE in
the preset is set to TAP. If the Tap LED does not
ash upon loading a preset, the Delay SOURCE
is set to TIME or MIDI. Regardless of the initial
setting, tapping the Tap button will temporarily
modify the current preset so that its SOURCE
becomes TAP.
To prevent the tempo from changing as you load
different presets, set GLOBAL TAP TEMPO in the
SYSTEM tab of the Setup menu to ON.
The Tap Button
To Next Page
Loading...
Need help?
General