56
The Edit Button
f WAVE
This lets you choose the modulation waveform
from Square,Triangle or Sine to vary the periodic
nature of the modulation effect.
f XFB L / XFB R
These send cross feedback from the left and right
delay lines (XFL L) and from right to left (XFR
L). Cross feedback returns the delayed audio to
the opposite side’s delay line. This can produce
interesting stereo effects.
f LOWCUT L / LOWCUT R &
HICUT L / HICUT R
These gentle highpass (LOWCUT) and low pass
(HIGHCUT) lters control the bandwidth of the
µMod feedback paths. These are very useful for
tailoring Flange effects.
f LEAD To UMOD
Sets the amount of lead voice sent into the
µMod block.
f HARM To UMOD
Sets the amount of harmony level sent into the
µMod block. The HARMONY effect must be on
to feed this send.
f LEAD LEVEL
Controls the lead (dry + Tone) voice level when
the individual effect is turned on with its respec-
tive footswitch. This allows a unique wet/dry mix
for individual effects. When multiple effects are
active, the lowest LEAD LEVEL value will deter-
mine the value.
Note that the LEAD EFFECT SENDS parameter
on the PRESET tab must be set to PRE in order
for any signal to get to the effect block when
LEAD LEVEL is set to OFF.
To Next Page
Loading...
Need help?
General