46
DVD Playback Operation
Preparation
1. Connect the unit to the power supply and press the POWER button to turn on the unit.
2. Repeatedly press the INPUT button on the remote control to select DVD mode and press the ENTER
button to enter.
3. Gently insert the disc, with the label side toward the front of the television, into the disc tray slot
until about half of the disc is in the tray and then the disc will be drawn into the disc tray and loaded
automatically.
Note: DVD mode must be selected before inserting disc.
4. Press the
EJECT button to eject the disc. The disc has to be reloaded manually by gently pushing
the disc back into the disc tray.
Warning: The use of poor quality discs could result in damage to the television.
DVD Playback
Region Code
DVD players and discs are coded by region. These regional codes must match the discs being played. If the
codes don not match, the disc cannot be played. This player’s default code is 4.
Play
Press the PLAY button to st
art playback.
Stop
During playback, press the ■ STOP button once to stop playback and press the ► PLAY button to
resume normal playback. Press the ■ STOP button twice to stop playback completely.
Pause
During playback, press the PAUSE button once to pause the playback; press it repeatedly to start
step-by-step playback. Press the ► PLAY button to resume normal playback.
To Next Page
Loading...
