4. PROGRAMMING OPERATIONS EO1-11154
4.10 Cashier Name and Status Programming
4-28
NOTES:
1. Cashiers 1 to 8 are programmed with the names “1CL” to “8CL” as default setting.
2. For the name of each cashier, a maximum of 12 one-byte or 6 two-byte characters can be entered. A
combination of both types is also available.
3. Training entry status is available for every cashier.
4. Prior to the change of cashier status (Normal cashier
→
Training cashier, or Training cashier
→
Normal
Cashier), daily reports and GT reports of this cashier should be taken.
3) Example
To program the following cashier data.
Cashier 1: JONES (cashier name), Training Cashier (status)
Operation LCD Display Remarks
When the ECR is being outside a sale
and in SET mode, depress the [↓] key.
The cursor is moved on to “2 NAMES”.
Depress the [2] or [Enter] key.
Depress the [↓] key twice.
The cursor is moved on to “3 CASHIER
NAME”.
Depress the [3] or [Enter] key.
The cashier name already
programmed is displayed.
While ? is shown on the upper-right corner
of the LCD display screen, the [?] key
depression results in that the following
guidance message appears on the LCD
display.
The [Enter] key depression allows the
ECR to enter Cashier 1 programming
mode menu.
(To program a desired cashier, select
the cashier with the [↓] key then
depress the [Enter] key.
While ? is shown on the upper-right corner
of the LCD display screen, the [?] key
depression results in that the following
guidance message appears on the LCD
display.
(continued on the next page)
To Next Page
Loading...
Need help?
General
