EasyManua.ls Logo

TEC MA-600 Series - Denmark Rounding

TEC MA-600 Series
164 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11. REGISTERING PROCEDURE AND PRINT FORMAT EO1-11154
11.30 Denmark Rounding
11-18
Without [ST] Key Operation:
Contents Key Operation Display Print
Item Entry
Cash Total
Cash Tender
123 [DP1]
[AT/TL]
200
[AT/TL]
DP01
01 1,23
CASH
1,25
2,00
CHANGE
0,75
DP1 1,23
SUBTL 1,23
CASH
1,25
SUBTL 1,23
TOTAL
1,25
CATEND 2,00
CHANGE 0,75
NOTE: Short-tendering can also be operated with or without a [ST] key depression. The balance due will be
calculated on the basis of the post-rounded sale total (or subtotal) amount. Thus, the post-rounded sale
total is determined on the first media entry (whether it is Totaling, Over-tendering, or Short-tendering
using any media key).
11.30 Denmark Rounding
1) Denmark Rounding feature
• Sale total finalized by the [AT/TL] key is rounded. (The fraction rounding method is fixed.)
• The amount displayed at the [ST] key depression is not rounded.
• Short-tendered amount to be displayed is not rounded.
2) Sale finalization
• At a total amount entry
When the [AT/TL] key is depressed, the post-rounded total amount (or short-tendered amount after
rounding) is finalized. When a sale is finalized by the media key excepting the [AT/TL] key, none of
rounding process is performed.
• At a tendered amount entry
When the [AT/TL] key is depressed, one of three processes below is performed according to the tendered
amount.
a) Tendered amount Post-rounded total amount (or short-tendered amount during a short-tendered
condition
An over-tendering is performed with the post-rounded total amount (or short-tendered amount).
b) Tendered amount < Post-rounded total amount (or short-tendered amount during a short-tendered
condition)
A short-tendering is performed with the pre-rounded total amount (or short-tendered amount).
c) Pre-rounded total amount Tendered amount < Post-rounded total amount
A tendering operation satisfying this condition is not possible.
Operation Example) If rounding method table below is programmed
Pre-rounded value of the
least effective digit
Post-rounded value
0 to 12 0
13 to 37 25
38 to 62 50
63 to 87 75
88 to 100 100

Table of Contents

Other manuals for TEC MA-600 Series

Related product manuals