EasyManuals Logo

TEC MA-600 Series User Manual

TEC MA-600 Series
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
11. REGISTERING PROCEDURE AND PRINT FORMAT EO1-11154
11.9 Amount Discount
11- 8
11.9 Amount Discount
- - - Dept or PLU item entry
(for discount from an individual item)
|Amount
| [ - ] - - -
- - - [ST]
(for discount from the sale total)
-- Receipt Print Format --
NOTES:
1. The discount amount must not exceed the item amount or the subtotal unless the “Credit Balance” option is
selected.
2. When the discount amount limit has been programmed, the Amount Discount operation on the discount
amount exceeding the limit is not possible in REG mode. As the discount amount limit is not effective in MGR
and - modes, the Amount Discount operation on a maximum of 7-digit discount amount is possible.
3. When the program option “non-print of the subtotal” has been selected, the subtotal is not printed even if the
Amount Discount operation is performed after the [ST] key.
4. After performing an amount discount operation, neither the Amount Discount operation nor the Percent
Charge/Discount operation is possible.
11.10 Percent Discount, Percent Charge
Dept or PLU entry [%-] (or [%+]) .................. for the preset rate
Positive Previous Balance entry (credit balance)
[ST] |Rate
| [%-] (or [%+]) ....... for the manual rate
NOTES:
1. Rate ............................................... 0.001 to 99.999 (%).
2. When no rate is preset, the value of rate should be entered.
3. When the Dept or PLU item entry is modified with [RTN MDSE] or [VOID], the following % entry will also be
modified with [RTN MDSE] or [VOID].
4. A % entry will cause an error if operated after a Negative Department/PLU.
5. Even when the rate is preset, an inputted numeric value will be activated as a rate. (Entry of the numeric
value 0 causes an error.)
6. A % entry after obtaining a subtotal is usually allowed only once. However, it can be programmed to allow
multiple times. (Ask your TOSHIBA TEC representative.)
7. You can select the rounding process of the fractions of the product (result of % calculation) from ROUND OFF
(initial setting), ROUND UP, and ROUND DOWN. (Ask your TOSHIBA TEC representative.)
-- Receipt Print Format --
OPERATION
DP
03 3,40
%-
5% -0,17
SUBTL 6,00
%-
10% -0,60
OPERATION
VEGETABLE 1,00
DISC -0,05
SUBTL 21,00
DISC -1,00

Table of Contents

Other manuals for TEC MA-600 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TEC MA-600 Series and is the answer not in the manual?

TEC MA-600 Series Specifications

General IconGeneral
BrandTEC
ModelMA-600 Series
CategoryCash Register
LanguageEnglish

Related product manuals