39
4 WIRELESS NETWORKING
DMS-CTC-20130613-0011 v1.0
Solid green
This indicates that you have successfully registered your wireless client. You are now connected to the MediaAccess
Gateway wireless network.
Blinking red
This indicates that the MediaAccess Gateway could not find your wireless client. Use the same procedure to try again
(you do not need to wait until the WPS LED on your MediaAccess Gateway turns off).
Procedure for WPS PIN code entry
Proceed as follows:
1 Check the label on your MediaAccess Gateway and write down the following information:
The PIN code that is printed next to the WPS logo.
The Network Name.
This is the default network name (SSID). If you already changed the MediaAccess Gateway’s network name, write
down the new one.
2 Go the WPS PIN code page of your wireless client.
3 Enter the PIN code,
4 Your wireless client may prompt you to select your access point. If this is the case, select the access point with the network
name that you wrote down.
Troubleshooting
If you are having trouble connecting your wireless client via WPS, this may be caused by one of the following reasons:
WPS can not be correctly executed:
Try again later and if the problem persists, configure your wireless manually. For more information, see “4.2 Connecting
your wireless client without WPS” on page 40.
Your wireless client is out of range:
If possible move your wireless client closer to your MediaAccess Gateway or use a wireless repeater to extend the range
of your wireless network and try again.
Another device is interfering on the selected wireless channel:
Change the radio channel of your MediaAccess Gateway access point and try again. For more information, see “Change
the wireless channel” on page 92.
Do not include the hyphen when entering the PIN code. For example, if your PIN code is 1234-5678, then enter
12345678.
To Next Page
Loading...
