Technicolor MediaAccess TG588v - Configuring the Upnp AV Media Server

55
6 SHARING CONTENT
DMS-CTC-20130613-0011 v1.0
6.2.1 Configuring the UPnP AV media server
Introduction
This section helps you to set up the MediaAccess Gateway UPnP AV media server
Enabling/disabling the UPnP AV media server
Proceed as follows:
1 Browse to the MediaAccess Gateway GUI.
For more information, see “Accessing the MediaAccess Gateway GUI” on page 31.
2 On the Toolbox menu, click Content Sharing.
3 In the Navigation bar, click Configure.
4 Under UPnP AV Media Server, click Server Enabled.
5 Click Apply.
Media database
When you plug in your USB storage device, the MediaAccess Gateway will automatically start building the media database.
This database lists all meta data that is embedded the your media files stored on your USB storage device.
To view the status of the media database:
1 Browse to the MediaAccess Gateway GUI.
For more information, see “Accessing the MediaAccess Gateway GUI” on page 31.
2 On the Toolbox menu, click Content Sharing.
3 In the Navigation bar, click Configure.
4 Under UPnP AV Media Server, you can find the Database Status.
5 If you want to rebuild the database, click Rebuild.