Technicolor TG788v v3 - Connecting Your Tg788 V V3 to Your Service Providers Network

15
2 Setting up your TG788vv3
DMS3-CTC-25-281 v2.0
2.2 Connecting your TG788vv3 to your service provider’s
network
Introduction
This section helps you to connect your TG788vv3 to your service provider’s network.
Connecting the cables
Proceed as follows:
1 Ta k e t h e D S L c a b l e .
2 Plug one end of the cable in the grey DSL port on the back of your TG788vv3.
3 If your delivery:
 Does not include a DSL splitter, plug the other end of the DSL cable into your telephone wall socket.
 Includes a DSL splitter, plug the other end of the DSL cable into the DSL/Modem port of the DSL splitter. Plug the
(LINE) cable of the DSL splitter into your telephone wall socket.
Only use the DSL cable provided in your package. Other DSL cables may not work optimally with the DSL
subscription that you purchased.
A splitter/filter is a box that typically has the following connectors:
•A Line input
•A Phone/PSTN output
•A DSL/Modem output (optional)
DSL