Technicolor TG788v v3 - Configuring WPA-Enterprise Encryption

28
3 Wireless networking
DMS3-CTC-25-281 v2.0
3.3.2 Configuring WPA-Enterprise encryption
Requirements
• A RADIUS server must be readily set up on your local network.
Procedure
Proceed as follows:
1 Browse to the TG788vv3 web interface.
For more information, see “4.1.1 Accessing the TG788vv3 web interface from your local network” on page 33.
2 Click Wireless. The Wireless page appears.
3 In the Security Mode list under Access Point, select one of the following modes:
 WPA2
 WPA+WPA2
4 The following RADIUS settings are now available for configuration:
 RADIUS Authentication Server's IP: enter the IP address of your RADIUS server.
 RADIUS Authentication Server's port: enter the WPA RADIUS Port.
 RADIUS Authentication Server's secret: enter the WPA RADIUS Key.
5 Click Save to apply your changes.
6 Reconnect your wireless client(s) to your TG788vv3.
For more information, see “3.2 How to manually connect a wireless client” on page 25.