23
3 Wireless networking
DMS3-CTC-25-281 v2.0
3.1 Connecting your wireless client via WPS
WPS
Wi-Fi Protected Setup (WPS) allows you to add new wireless clients to your local network in a secure and easy way, without
the need to enter any of your wireless settings (network name, wireless key, encryption type).
Requirements
• Your wireless client must support WPS. Consult the documentation of your wireless client for this.
•Your TG788vv3 must use WPA2 PSK or WPA+WPA 2 PSK encryption or no encryption (default encryption).
• The WPS function must be enabled on your TG788vv3. This is the default setting.
WPS Methods
The following WPS methods are supported by your TG788vv3:
• Push Button Configuration (PBC):
You simply push the WPS button on both your wireless client and your TG788vv3 to connect them to each other. See
“Connect your wireless client WPS PBC” on page 23.
• PIN code entry on the wireless client:
You enter the PIN code of your TG788vv3 on the configuration utility of your wireless client to connect them to each
other. See “Connect your wireless client using WPS PIN code entry on the wireless client” on page 24.
• PIN code entry on your TG788vv3:
You enter the WPS PIN code of your wireless client on the TG788vv3 web interface to connect them to each other. For
more information, see “Connect your wireless client using WPS PIN code entry on your TG788vv3” on page 24.
Connect your wireless client WPS PBC
Proceed as follows:
1 Shortly press the WPS button on your TG788vv3:
The following operating systems have native WPS support:
• Windows supports WPS from Windows Vista Service Pack 1 onwards.
• Android supports WPS from Android 4.0 (Ice Cream Sandwich) onwards.
• BlackBerry supports WPS from BlackBerry 6 onwards.
WPS cannot be used in combination with the following encryptions:
• WPA2 via a RADIUS
• WPA via a RADIUS
• WEP
Make sure that you know how to start WPS on your wireless client before you start. Consult the documentation of
your wireless client for more information.
WPS