To Next Page

To Previous Page

3 Wireless networking

DMS3-CTC-25-281 v2.0

2 The WPS LED starts blinking orange. This indicates that your TG788vv3 is now searching for wireless clients that are in

registration mode. You now have two minutes to start WPS on your wireless client.

3 Start WPS PBC on your wireless client.

4 Your TG788vv3 provides its wireless settings to the wireless client.

5 At the end of the WPS process, the status of the WPS LED on your TG788vv3 will change to either of the following:

 Solid green

This indicates that you successfully registered and connected this wireless client. You are now connected to your

TG788vv3 wireless network.

 Blinking red

This indicates that your TG788vv3 could not find any wireless client in WPS pairing mode or that the exchange of the

wireless settings and/or registration failed. For more information, see “Cannot connect via WPS” on page 75.

Connect your wireless client using WPS PIN code entry on the wireless client

Proceed as follows:

1 Check the label on your TG788vv3 and note the following information:

 The PIN code that is printed next to the WPS logo.

 The Network Name.

These are the default values. If you already changed these settings, use the new settings instead.

2 Go to the WPS PIN code entry page of your wireless client. Consult the documentation of your wireless client for more

information.

3 Enter the PIN code,

4 Your wireless client may prompt you to select your access point. If this is the case, your access point will be listed with its

Network Name.

Connect your wireless client using WPS PIN code entry on your TG788vv3

Proceed as follows:

1 Locate and note the WPS PIN of your wireless client. For more information, consult the documentation of your wireless

client.

2 Browse to the TG788vv3 web interface.

For more information, see “4.1.1 Accessing the TG788vv3 web interface from your local network” on page 33.

3 Click Wireless. The Wireless page appears.

4 In the WPS Device PIN code box under Access Point, type the PIN code of your wireless client and click Set PIN code.

In case of problems

If you are having trouble connecting your wireless client via WPS, see “Cannot connect via WPS” on page 75 for more

instructions.

Do not include the hyphen when entering the PIN code. For example, if the PIN code is 1234-5678, then enter

12345678.

You can find the default network name on the label on your TG788vv3.

1234-5678

Technicolor TG788v v3 User Manual

Other manuals for Technicolor TG788v v3