Technicolor TG788v v3 - Page 63

59
5 Content and Printer Sharing
DMS3-CTC-25-281 v2.0
Customizing the content sharing settings
To change the default settings, proceed as follows:
1 Browse to the TG788vv3 web interface.
For more information, see “4.1.1 Accessing the TG788vv3 web interface from your local network” on page 33.
2 Click Content Sharing. The Content Sharing page appears. Under General status, you can change the following
settings:
 Samba name:
Your TG788vv3 will share the content to the Samba devices under this name.
 Samba enabled:
Allows you to enable or disable the Samba file sharing server.
 DLNA enabled:
Allows you to enable or disable the DLNA service.
 DLNA name:
Your TG788vv3 will share the content with other DLNA devices under this name.
3 When you click show advanced, you will be able to configure the Samba name and DLNA name. On top of that you
can also change the:
 Samba workgroup:
Enter the same workgroup as used by your computer(s).
 Samba description:
Add a short description for the TG788vv3 shared content.
4 Click Save.
5 All users connected to your TG788vv3 can now access the data stored on the storage device(s) that are connected to
your TG788vv3.