Technics RS-DC10 - Page 52

Timer Playback/Recording
If this deck is used with an audio timer or a tuner particular time to serve as a wake-up call or for the
equipped with a timer available from an audio store, it recording of a particular radio broadcast to be
is possible for a tape to be played back ata commenced automatically.
Preparation:
Load the cassette tape for playback. (See page 17 for
DCC tapes and page 27 for analog cassette tapes.)
Techases sara covract casserre ofc meocis we
1 Start playback, adjust the amplifier’s
{ volume and tone controls and stop
(signal system connections are omitted) the tape where playback is to
Connect the power cords of the components as
shown in the figure below. (For further details, commence.
refer to the Operating Instructions of the timer to oo ne
: be connected to the deck.) Se ean: 2 __TMER ___-.. Set this selector to
|
Power
outlet
pay,
OFF
nec
PLAY.
' eel ©
Aufio timer or tuner equipped
with timer from an audio store
Connections
3 Set the tlmer to the desired time.
The deck’s power is now tumed off.
: | AC IN~
' | When the time set by the timer is reached, the deck’s
oI power is turned on and playback starts automatically.
(BS) tuner (option)
Display during timer operation
ae
Rin aS
AC OUTLET AC IN~
Amplifier (option)
®Leave the power supplied to the amplifier so that power
will be supplied to the deck when it becomes activated by
the timer.
©The repeat mode is released during timer playback.
After timer playback has ended, return the timer switch to
the OFF position.
r—
Soo
Deck
Household AC outlet Or