Technics RS-DC10 - Page 56

Niico)ble)(=\-)alere)ilalemelelie(=
Before requesting service for this unit, check the chart
below for a possible cause of the problem you are
experiencing. Some simple checks or a minor
adjustment on your part may eliminate the problem and
restore proper operation.
The unit is placed in the
record or play mode as
soon as the power is
switched on.
If you are in doubt about some of the check points, or if
the remedies indicated in the chart do not solve the
problem, refer to the directory of Authorized Service
Centers (enclosed with this unit) to tocate a convenient
service center, or consult your dealer for
instructions.
Suggested remedy
Press stop button and set timer
switch to OFF.
Tape travels but no
playback sound is heard.
Amplifier's volume control is at
minimum position.
ee |
Adjust amplifier’s volume by
turning its volume control.
Amplifier's selector is not at DAT |
or TAPE. 9
Connection has been made to |
variable output connector and
level has been turned down to
minimum.
Noise or distortion in
playback sound.
Recording level is much too high
or much too low.
Playback sound is broken
and disconnected.
Dirty head section.
2:
36
58
Worn-out cassette tape.
Something is wrong with
sound quality when
analog cassette tapes are
played back.
Dolby NR switch set to wrong
position.
| Set selector to position
corresponding to what is 8
connected to deck (DAT or TAPE).
| Adjust level using remote
controller.
9.
Record again at proper recording
level.
Clean the heads using an optional
cleaning tape and re-record.
j Use a new cassette tape.
Set Dolby NR to same mode as
that used for recording. |
No analog input recording.
Bo
Cassette tape’s accidental
erasure prevent tab is closed.
| Set tab to open position.
Le
W
Improper connections with stereo
ampilitier.
j——
Connect properly.
ie
Recording level control at “0” |
position. {
Digital input mode has been
established.
| Set input selector to proper
j position.
Adjust recording (Input) level using 36
recording level control.
34