(TPS:Tape Program Sensor)
• During operation of the TPS function, the play indicator will
flash quickly.
• To find the beginning of a track which is several tracks before
or after the track currently being played, repeat the procedure
until the desired track is found
• ff the reverse mode is set to "_" or "_ ", when the end
of the tape is reached, operation will switch to the other side of
the tape and the TPS function will continue to operate.
Jm
Because the TPS function utilizes the blank spaces between
tracks, it may not be able to function properly under the following
conditions:
• When there is less than 4 seconds of silent interval between
tracks
=When there are no completely silent intervals (such as when
the tape has been recorded using a microphone)
• When there are especially low-level parts or silent parts inside a
track (such as sometimes occurs in classical music)
• If the <1, or I_1_ button Is pressed when less than 10 seconds
has elapsed from the beginning of the track or there is less than
10 seconds remaining to the beginning of the next track
• If the tracks have been recorded with a fade-in (a gradual In-
crease in the recording level) or a fade-out (a gradual decrease
in the recording level)
[-ms] [While tape Is being played back]
L__'_ I '___1 Press <1_1 or I_1_.
"_ tape will be re-wound or fast-forwarded to_,<"_('l'he
the beginning of the track, and then playback
will automatically begin.)
.............. ,°,,......° ..... .°. .........................
Because this unit Is capable of playing back both sides of the
tape, the operation changes in accordance with the direction of
the tape side indicator
Tape side
Indicator
Tape returns to the
beginning of the
track currently
being played, and
playback begins.
Playback begins
from the
beginning of the
next track
!-;-I
81-) I G t = 8/-113 F/1"3
ILIL '.- 3 I " / LIL'.UI-I
'l""""""2"""
Deck 1 IHI Indication Deck 2 HLH.JIndication
To return to the normal speed during high.speed
tape transport
Press the _1<1 or II_1_ button corresponding to the current direc-
tion of tape travel.
AW
Depending on the amount of tape on the take-up and supply
sides, the tape may not be transported at high-speed
11
To Next Page
Loading...
Need help?
General
