Technics RS-TR575

Before requesting service for this unit, check the chart below for
a possible cause of the problem you are experiencing. Some sim-
ple checks or a minor adjustment on your part many eliminate
the problem and restore proper operation.
If you are in doubt about some of the check points, or If the
remedies indicated in the chart do not solve the problem, refer to
the directory of authorized service centers (enclosed with this
unit) to locate a convenient service center, or consult your
Technics dealer for instructions.
(In U.S.A. consult MSC Authorized Servicenters for detailed in-
structions.)
I
Problem
Probable cause(s)
I
Suggested remedy
I
Tape moves but no sound is
heard.
Distorted sound.
Previously recorded sound
has not been erased.
Sound output Is hoarse or
unsteady.
Poor sound quality
(especially In the high
treble and low bass ranges).
Sound Is low, poor tone,
Intermittent sound noise.
A "hum" noise Is heard
dudng tape playback or
recording.
Recording Is not possible.
The volume control of the receiver is set to its
minimum position.
The input selector of the receiver is not set to the
"TAPE" position.
The recording level is too high.
Erase head is dirty.
Headsare dirty.
Tape is damaged.
The correct Dolbynoise-reduction button is not
set.
Heads, capstan andlor pinch roller are dirty or
tape is damaged.
This unit is placed too close to a receiver,
amplifier or tuner.
The recording level control is at the "0" position.
One of the tape-to-tape recording-speed
indicators (" x 1" or "_]") is illuminated.
TV noise Is accidentally This unit is placed near a "IV.
recorded.
• Adjustthe volumecontrolto the desired level.
• Set to the "TAPE" position.
• Select the appropriaterecordinglevel.
• Clean the head.
• Clean the heads.
• Try operationwitha new cassette; if there is no
problemwiththe newcassette,discardthe damaged
cassette.
• Set it to the correct position.
• Clean the heads, capstan andlor pinch roller, or try a
new cassette.
• Leave as much space as possible between the units,
or place them where there is the least amount of
"hum".
• Select the appropriate recording level.
• Switch OFF whichever tape-to-tape recording speed
indicator is illuminated (by pressing the SPEED
button).
• Try placing this unit further away from a TV.
22