1 3
J
I-'71,1
_2
I'1"1
12
r-_
)ECK 2
,i,r
To record selected tracks
....... 0 ..........................................
During recording, press •
on Deck 1.
(Deck 1 will stop, and Deck 2 will
record a 4-second silent interval and
then enter the recording standby
mode.)
i [
To cut unwanted parts during
recording
..... P,USE...... Press ii PAu$E on"'0eck2
durlng recording.
_'_ (Deck 2, which was recording, will
',:,.J enter the pause mode, and Deck 1 will
continue playback.)
" ;;.r.;.D.ck''1to'ii"d'th;tr;ck""yo.
wish to record.
It isalso possible to change the playback tape at this
time.
For your reference:
The TPS function is useful for finding the beginning of
the track. (Refer to page 11.)
.....;_usE......_;._,nD_,c.ir;_c._,_._;_ouw,_
to record]
_k_-_ Press II PAUSE on Deck 2.
(Deck 2 will resume recording.)
[_ (Recording will resume.)
To stop recording
Press • on Deck 2.
(On Deck 2)
For your reference:
• The recording level and the Dolby effect will be recorded as
they are on the tape being played back.
• Because the signal being recorded from Deck 1 onto Deck 2
does not pass through the receiver, it is possible to change the
setting of the receiver's input selector during recording in order
to listen to some other sound source.
J,
When recording with the recording speed set to double speed,
noise interference may be recorded onto the tape if there is a
television set nearby, so make the recording in a location
separated from the television set or switch off the television set
during recording.
19
To Next Page
Loading...
Need help?
General
