Technics RS-TR575M2

Name
Ref.page No.
Name
Ref.page
©Power STANDBY © ON” switch
(POWER, m . STANDBY (I) * ON).6
Press to switch the unit from on to standby mode or vice versa.
In standby mode, the unit is still consuming a small amount of
power.
©Cassette holder
©"STANDBY” indicator (STANDBY)
With the POWER button in the ON position (_ ™ _) the unit can be
switched between the STANDBY and ON condition using a
remote control. In the STANDBY condition the indicator will light.
©Remote control signal sensor
This cassette deck can be operated by using the remote control
provided with a Technics amplifier or receiver. (For detailed
information, refer to the operating instructions of the amplifier or
receiver.)
©Display
©Reverse-side playback button ( ◄ ) . 6
©Stop button ( ■ ) . 6
© Forward-side playback button ( ► ) . 6
©Auto tape calibration button (ATC).11
® Open/close button (± OPEN/CLOSE).6
©Counter reset button
(COUNTER 1 (2) RESET).10
©Recording-balance control (BALANCE).12
©Recording-level control (REC LEVEL).12
©Dolby noise-reduction button (DOLBY NR).6
© Reverse-mode select button
(REVERSE MODE).6
© Rewind/fast-forward search buttons
( ◄ ◄ / ► ► [TPS]).8,9
© Pause button (II PAUSE).6
©Automatic-record-muting button
(O AUTO REC MUTE).17
©Record button (# REC).11
©Synchro-start button (SYNCHRO START).15
® Headphone jack (PHONES).10
©Tape-to-tape recording-speed button
(SPEED X1/[X2l).15
4