Enjoying the sounds
21
RQT5730
Operations
Press [MUTING].
The message “MUTING ON NOW” runs repeatedly from right to left
across the display as long as the muting function is on.
To cancel
Press [MUTING].
Muting is also canceled when the unit is turned off.
Muting the volume
You can adjust the volume of the subwoofer while listening to a
source. No sound is heard from the subwoofer if “SW ---” is
selected. This setting can be done for each DSP mode.
You cannot adjust the subwoofer level while the DSP is defeated or
if DVD 6CH INPUT is selected.
The factory setting is “SW 10”.
Press [SUBWOOFER LEVEL].
The current setting is shown.
Each time you press the button:
SW --- / SW MIN / SW 5 / SW 10 / SW 15 / SW MAX
↑
To make finer adjustments
1 Press [LEVEL] to select “SW”.
2 Press [–] or [+].
Sound from the subwoofer can be distorted if you raise the unit’s
volume while subwoofer level is high. Reduce subwoofer level if this
occurs.
Note
Adjusting the subwoofer level
Use the tape monitor if you have connected a graphic equalizer to
the TAPE terminals.
Press [TAPE MONITOR].
The “TAPE MONITOR” indicator lights and the tape monitor comes
on.
Sources other than tape can still be selected with [INPUT
SELECTOR] while the “TAPE MONITOR” indicator is on.
Press [TAPE MONITOR] again to turn the tape monitor off.
(
\
See “Making a recording” on page 24 for details on how to use
the tape monitor during recording.)
¡The tape monitor cannot be used when input is digital and turns
off if you select digital input.
¡Depending on the setting, the graphic equalizer can cause
distortion.
Note
Using the TAPE MONITOR
A
B
C
To Next Page
Loading...
