Making a recording
24
RQT5730
¡ You cannot record a source connected through a digital terminal.
When recording CD, DVD, or TV, ensure the source is connected
through the corresponding analog terminals (
\
pages 6–7) and
“ANALOG” input is selected (
\
page 18).
¡ When you select DVD 6CH INPUT mode, only sound from the
front left and right channels is recorded.
Note
You can record to a tape deck connected to TAPE REC (OUT) or to
a VCR connected to VCR 1 (or VCR) OUT.
See the recording unit’s operating instructions for details on how to
prepare it for recording.
When recording with a tape deck, you can record any source
except TAPE.
When recording with a VCR, you can record any source except
TAPE or VCR 1/2 (or VCR).
1 Turn [INPUT SELECTOR] to select the
source to be recorded.
2
If you selected “VCR 1” in step 1, set
[VCR 1
ll
, VCR 2
kk
] to the required
position.
3 Begin recording.
Follow your recording unit’s operating instructions.
4 Begin the source to be recorded.
Follow your equipment’s operating instructions.
SA-DX1050 only
Recording on a tape deck or VCR
A
To monitor sound being recorded onto a tape deck
B
It is possible to check the sound being recorded if your tape deck is
a 3 head system.
Press [TAPE MONITOR] on this unit and
set the monitor button on the tape deck to
“TAPE”.
Press [TAPE MONITOR] once again to turn it off.
If you make a mistake in operation or if sound output stops, the
HELP function displays information that indicates how you can
remedy the situation.
If “ERROR” or scrolling characters (“SPEAKER OFF NOW”, for
example) appear on the display, do the following.
Press [-HELP, –RESET].
The remedy for the situation is displayed.
For your reference
You can reset the unit’s settings to the factory settings. If this is ever
necessary, press and hold [-HELP, –RESET] for about 2 seconds
until “RESET” is displayed.
This will not erase radio stations you have preset.
The HELP function
To Next Page
Loading...
