The radio
23
RQT5730
Radio functions
Preset tuning
Choose either automatic presetting, which presets the stations the
tuner can receive, or manual presetting, which allows you to select
the stations to preset and the order in which they are to be preset.
There are 30 channels available for presetting.
Remember
If a new station is preset into a channel, the old station is erased.
Presetting FM stations
Preparation: Tune to the FM frequency where you want to begin
presetting (
\
page 22).
Press and hold [MEMORY].
The FM stations the unit can receive are preset in channels 1 to 30.
Presetting AM stations
Preparation: Tune to the AM frequency where you want presetting
to begin (
\
page 22).
Press and hold [MEMORY].
The AM stations the unit can receive are preset in channels 21 to
30. (FM stations are replaced if any were preset in these channels.)
During automatic presetting, the memory indicator flashes and the
frequency scrolls. The memory indicator and channel numbers are
displayed for a second when a station is preset (ı).
The last station to be preset is displayed when presetting finishes.
For your reference
Even if the power supply cord is disconnected from the household
AC outlet, the stations remain in memory for approximately one
month.
Automatic presetting
Preset the stations one at a time.
11
Tune to the station.
22
Press [MEMORY].
33
Press [TUNING
22
or
11
] to select a channel.
44
Press [MEMORY].
Manual presetting
1 Press [PRESET].
The channel number flashes for about 5 seconds.
2 Press [TUNING
22
or
11
].
Hold down the buttons to change channels faster.
On the remote control
Press [CH 2 or 1].
or
Press the numbered buttons.
For channels 1 to 9, press the corresponding number.
For channels 10 or over, press [≥10/ENTER], then the two digits.
e.g. To select channel 21 [≥10/ENTER] / [2] / [1]
Selecting channels
To Next Page
Loading...
