TechniSat Digit ISIO S2 User Manual

21
6 Basic operation
Dear Customer
The following section starts by covering basic operation as well as recurrent operating
steps for the TV. This should make it easier to read the instruction manual, since it avoids
repeated description of identical steps at each individual stage.
If a function or setting for the device has to be different from the basic operation, the
difference in operation is described in detail at the relevant point in the instruction manual.
The so-called "On Screen Display" is used on your TV. This simplifies operation of the
television since the buttons on the remote control can take on different functions. This
makes it possible to reduce the number of buttons.
In this On Screen Display (OSD for short) the selected functions or settings are highlighted
by a marking.
Furthermore, you will see a line at the bottom edge of the screen in which the various
buttons on the remote control are shown with their current functions.
In this instruction manual the terms shown in the OSD as well as the buttons to be
pressed are distinguished from the rest of the text by the print format used.
Warning - indicates an important note which you absolutely should observe in order to
avoid problems with the device, loss of data or unwanted operation.
Tip - indicates a note about the function described as well as other functions
associated with it and any others to be observed with reference to the respective place
in the instruction manual.
6.1 Switching the television on/off
> When the receiver is in standby mode, you can switch it on by pressing the
On/Standby button on the remote control/device.
> When operating normally you can switch the device to standby mode by pressing the
On/Standby button.
When switching the receiver on and off, note section 8.1 as well.
6.2 Calling up the main menu and navigating through the menus/functions
The following example will illustrate how you reach the main menu and call up a submenu.
The objective of the example is to call up the Picture settings menu.
> Press the Menu button. The main menu appears on the screen.

TechniSat Digit ISIO S2 Specifications

General

Signal source	Satellite
Digital signal format system	DVB-S, DVB-S2
Personal Video Recorder (PVR) included	-
Tuner type	Digital
Product color	Silver
Number of tuners	2 tuner(s)
Channels quantity	10000 channels
Audio output channels	- channels
Favorite list TV programs	10000
Digital Satellite Equipment Control (DiSEqC)	1.0, 1.2, Sat-CR
Audio formats supported	FLAC, M4A, MP2, MP3, OGG, WAV
Image formats supported	BMP, GIF, JPG, PNG, TIF
Video formats supported	ASF, AVI, H.264, MKV, MOV, MP4, MPEG1, MPEG2, MPEG4, MPG, TS, TS4, VOB, WMV
Built-in HDD	No
USB 2.0 ports quantity	3
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	0
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.2 W
Power consumption (typical)	13 W
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	10 - 75 %
Display type	VFD