TechniSat Digit ISIO S2 User Manual

5
3 Please read this first
Before connecting and using the device, first check that everything has been supplied and
familiarise yourself with the safety instructions.
You should have received:
1 digital receiver, 1 quick start manual, 1 CD-ROM,
1 remote control, 1 mains power cable, batteries (2 x 1.5 microcells)
3.1 Safety advice
For your own protection you should read the safety precautions carefully before using your
new receiver.
The manufacturer accepts no liability for damage caused by inappropriate handling, or by
non-compliance with the safety precautions.
Function-related discharge current may occur with electrical equipment. This is
acceptable and poses no risk, even if it is experienced as a slight tingling.
To prevent such discharge current, mains operated devices (receivers, TVs etc) must
always be installed or connected with the power switched off, i.e. all devices must be
disconnected from the mains.
- The receiver must only be operated in a temperate climate.
- To ensure adequate ventilation, place the receiver on a flat, horizontal surface and
do not place any objects on top of it. There are ventilation slots here to allow heat to
be dissipated from the interior of the unit.
- Do not place any burning objects, such as lit candles, on top of the receiver.
- Do not expose the receiver to water droplets or water spray, and do not place
any objects filled with liquid, such as vases, on top of it. If water gets into the unit,
immediately disconnect the mains plug and inform the service department.
- Do not operate any sources of heat near the TV which may also heat it up.
- Do not obstruct the ventilation slots.

TechniSat Digit ISIO S2 Specifications

General

Signal source	Satellite
Digital signal format system	DVB-S, DVB-S2
Personal Video Recorder (PVR) included	-
Tuner type	Digital
Product color	Silver
Number of tuners	2 tuner(s)
Channels quantity	10000 channels
Audio output channels	- channels
Favorite list TV programs	10000
Digital Satellite Equipment Control (DiSEqC)	1.0, 1.2, Sat-CR
Audio formats supported	FLAC, M4A, MP2, MP3, OGG, WAV
Image formats supported	BMP, GIF, JPG, PNG, TIF
Video formats supported	ASF, AVI, H.264, MKV, MOV, MP4, MPEG1, MPEG2, MPEG4, MPG, TS, TS4, VOB, WMV
Built-in HDD	No
USB 2.0 ports quantity	3
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	0
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.2 W
Power consumption (typical)	13 W
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	10 - 75 %
Display type	VFD