Techno CNC Systems 60120 - Safety Instructions

4
Call: 1-631-648-7481 or Visit: support.technocnc.com
Titan Series WinCNC Manual
WinCNC
1. Keepngers,hands,andallotherobjects
away from machine while power is on.
2. Disconnect power to all system components
when not in use, when changing accessories,
and before servicing.
3. Do not loosen, remove, or adjust machine
parts or cables while power is on.
4. Exercise care with machine controls and
around keyboard to avoid unintentional
starting.
5. Make sure voltage supplied is appropriate to
specicationsofcomponents.
6. Machines must be plugged into three-
pronged grounded outlets. Do not remove
the grounding plug or connect into an
ungrounded extension cord.
7. Keep cables and cords away from heat, oil,
and sharp edges. Do not overstretch or
run them under other objects or over work
surfaces.
8. Useproperxturesandclampstosecure
work. Never use hands to secure work.
9. Do not attempt to exceed limits of machine.
10. Do not attempt to use machine for purposes
other than what is intended.
11. Use machine only in clean, well-lit areas
freefromammableliquidsandexcessive
moisture.
12. Stay alert at all times when operating the
machine.
13. Always wear safety goggles.
14. Donotwearloose-ttingclothingwhen
operating machine. Long hair should be
protected.
15. Always maintain proper balance and footing
when working around the machine.
16. Maintainequipmentwithcare.Keepcutting
tools clean and sharp. Lubricate and change
accessories when necessary. Cables and
cords should be inspected regularly. Keep
controls clean and dry.
17. Before using, check for damaged parts. An
authorized service center should perform
all repairs. Only identical or authorized
replacement parts should be used.
18. Remove any adjusting keys and wrenches
before turning machine on.
19. Do not operate the machine unattended.
20. Follow all safety instructions and processing
instructions in the MSDS for the material
being processed.
21. Use proper precautions with dust collection
systemstopreventsparksandrehazards.
22.Makesuretohaveproperreextinguishing
equipmentonhandatalltimes.
WARNING: IMPROPER OR UNSAFE OPERATION OF THE MACHINE WILL
RESULT IN PERSONAL INJURY AND/OR DAMAGE TO THE EQUIPMENT.
READ THESE INSTRUCTIONS THOROUGHLY BEFORE OPERATING MACHINE.
DO NOT OPERATE MACHINE IF YOU ARE UNFAMILIAR WITH THESE SAFE
OPERATING INSTRUCTIONS. DO NOT OPERATE MACHINE WITHOUT
KNOWING WHERE THE EMERGENCY STOP SWITCH IS LOCATED.
PREVENT FIRE HAZARDS by using the proper feeds, speeds, and tooling while
operating your Techno machine. For example, setting feeds and speeds too low
and/or using dull tool bits creates friction at the material. The friction generates
heat which can result in a re that can be drawn through the vacuum table or
dust collector without warning. Fire hazard from friction heating caused by dull
tools is possible when cutting certain materials, especially composite material
such as wood composites, MDF and Particleboard. © 2012
Safety Instructions