GLIDEX 600 XTPRO: Service & Maintenance Manual - rev. 1.1
Page 7.9
7.8. DISASSEMBLING THE FRAME GUARDS
Figure 7.8-1
Carry out the procedure described in paragraph
7.6. “Disassembling the levers”.
On each side:
1. Back off the 3 screws a using a large Phillips
screwdriver.
2. If present, back off the screw inside the
guard, situated in the upper part between the
levers. It can be accessed from the outside
using a large Phillips screwdriver fitted with
an extension.
3. Back off screw b using a large Phillips
screwdriver.
4. Open out the sides of the FRAME GUARD
and remove it by pulling upward.
To reassemble the FRAME GUARD, carry out
the above steps in reverse order.
To Next Page
Loading...
