EasyManua.ls Logo

Technogym Glidex 600 XTPRO - 10.3.6. Checking the State of Wear of the Alternator Belt; 10.3.7. Lubricating the Lever Group; 10.3.8. Checking the Operation of the Cardio Receiver; 10.3.9. Checking the Operation of the Hand Sensor Receiver

Technogym Glidex 600 XTPRO
90 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GLIDEX 600 XTPRO: Service & Maintenance Manual - rev. 1.1
Page 10.4
10.3.6. CHECKING THE STATE OF WEAR OF THE ALTERNATOR BELT
1. Check the state of wear of the belt, turning it by hand using the alternator flywheel. In particular,
check the edges and the inner part of the belt. Replace if it shows evident signs of wear.
2. Check the tension and the alignment of the belt. Adjust them if necessary.
10.3.7. LUBRICATING THE LEVER GROUP
1. Check the state of wear and the play of the lever group and the footboard swivel system. Adjust
if necessary.
2. Lubricate the bearings and joints using spray grease.
3. Check the condition and adhesion of the 4 shock absorbers under the pedals.
10.3.8. CHECKING THE OPERATION OF THE CARDIO RECEIVER
1. Using a separate heart rate monitor, put on the transmitter strap and check that the machine and
the separate monitor both measure the same heart rate, and that when the strap is disconnected
the machine does not receive any signal.
2. Using a heart rate frequency simulator, check that the machine detects the variations in the heart
rate.
3. If the machine is equipped with a coded receiver (PCD technology), put on the coded strap and
wait for the machine to display the measured heart rate. At this point, using a heart rate
frequency simulator, check that the machine does not detect its presence and doesn’t alter the
previously measured heart rate.
10.3.9. CHECKING THE OPERATION OF THE HAND SENSOR RECEIVER
1. Using a separate heart rate meter, check that, when the sensors are gripped, both the machine
and the separate meter read out the same frequency, and that when the sensors are released the
machine does not detect any signal.
10.3.10. CHECKING THE RESISTANCE SETTING
1. Select the manual training program and check that, when the difficulty level is changed, the
resistance of the machine varies accordingly.
10.3.11. CHECKING THE NOISE OF THE BRUSHES
1. With no workout program selected, check that the alternator brushes do not make any noise.
Replace them or smooth down their profile if they show evident signs of wear.

Table of Contents

Related product manuals