Technogym Kinesis - Lifting and Moving the Equipment

24
1.8 Lifting and moving the equipment
Before moving the equipment you must take off the side, upper and intermediate protective
panels, next, release the frame from the wall or floor mounting: follow the instructions described
in the assembly manual, in reverse order.
The modules can only be moved one at a time and therefore all double units have to be separated:
follow the instructions described in the assembly manual, in reverse order.
The equipment can be moved using normal lifting and carrying machines.
To avoid damaging the panel and for greater stability, the equipment must be lifted from the
weight stack side, after moving it away from the wall to allow access to the weight stack.
DANGER
Move the equipment very carefully to avoid overbalancing.
WARNING
Move the equipment by holding the frame only: do not put any strain on the protective
panel.
If you can’t get access to the weight stack, remove the equipment’s arms and protective
panel, following the instructions described in the assembly manual, in reverse order. In these
circumstances you are advised NOT to withdraw the cable completely from the arms:
- in the Alpha, Beta, Omega and One modules the cable should remain inserted in the lower
arm;
- in the Gamma module the cable should remain inserted in the upper arm;
- in the Delta module the cable should remain inserted in the lower arm and handgrip.
1 teChniCal inforMation