Technogym LED - The Custom Maximal Test

25
Crossover, Synchro, Vario, Bike, Recline, Climb, Step, Top - Advanced LED display
The tests
The custom maximal test
The custom maximal test is available in Top Excite. This test is for very t users in good state of health.
To perform this test, in addition to age, weight and gender, you must also set the workloads.
ttowwtt
Type in the test starting power with the number keys, then press ENTER to conrm and proceed.
owwtt
Type in how much the load must increase between one step and the next with the number keys; then press ENTER to conrm and proceed.
tt
Type in the time, in minutes and seconds, for each step with the number keys; then press ENTER to conrm and proceed.
There is no specic warm up stage; therefore you are advised to set the rst step or steps with appropriate loads or to warm up for a few minutes before the test.
The test ends when the user is exhausted and presses the STOP key.
During the cool down the results are scrolled on the alphanumeric display:

ot34
t3
owwtt