27
Crossover, Synchro, Vario, Bike, Recline, Climb, Step, Top - Advanced LED display
The tests
The Air Force PRT test
You need to wear the heart rate monitor to do the Air Force test; if there is no heart rate signal the test does not start.
To start the test, you must enter your age, weight, gender and number of workouts per week.
The test has a warm up stage lasting 2 minutes at 50 watts; then the workload increases to bring the heart rate up to over 125 beats per minute.
The increase in workload depends on age, gender and training level.
The goal of the test is to keep the heart rate at over 125 beats per minute for 6 minutes at a constant power.
If the heart rate has not reached the value required for the test, the power is increased every 2 minutes; the 6 minutes required to calculate the results start
from the last workload increase.
stage time workload
warm up 2 minutes 50 watts
1 2 minutes increase based on set parameters
2 2 minutes
+ 50 watts if HR is lower than 110
+ 25 watts if HR is between 111 and 120
+ 0 watts if HR is higher than 120
n 2 minutes like step 2
Before starting, if the heart rate is already higher than 110 beats per minute when the data is entered, the test does not start.
During the test, it is important to maintain a pedal speed of between 50 and 80 rpm.
To Next Page
Loading...
