Technogym Skillmill - 12.10 REVISION 3.2; 12.11 REVISION 3.3; 12.12 REVISION 3.4; 12.13 REVISION 3.5

Skillmill
Technical Service Guide - Rev. 3.5
Page 132
email: support@technogym.com
12.10 REVISION 3.2
Modication to paragraph §3.1.6 BATTERY. Baery operation description updated. Emphasis on
the fact that the Skillmill baery must never be connected to USB cables other than the original,
approved one on the machine itself.
Modication to paragraph §6.6.2 THE DISPLAY DOES NOT TURN ON AT ANY SPEED (CONSOLE
VERSION): troubleshooting procedure updated.
New paragraph §6.9 EQUIPMENT TESTING AFTER THE INTERVENTION OF TECHNICAL
SERVICE.
Modication to paragraph §6.4.1 STEPS NEEDED TO CONFIGURE THE SKILLMILL CLASS: step
9 modied.
12.11 REVISION 3.3
Change to paragraph §6.6.2 THE DISPLAY DOES NOT TURN ON AT ANY SPEED,
WHETHER HIGH OR LOW (CONSOLE VERSION).
Modication to paragraph §6.7.1 SKILLMILL (CONSOLE AND CONNECT) CALIBRATION
PROCEDURE THAT DOES NOT ACTIVATE THE BACKLIGHTING OF THE KEYS
and §6.7.2 SKILLMILL (CONNECT) CALIBRATION PROCEDURE THAT ACTIVATES
THE BACKLIGHTING OF THE KEYS: a note about checking correct calibration has been
added.
New paragraph §6.7.3 AUTOMATIC CORRECT CALIBRATION CHECK.
Modication to paragraph §9.1 SW UPDATE PROCEDURE: a note about SW updating has been
added.
12.12 REVISION 3.4
Modication to paragraph §6.6.2 THE DISPLAY DOES NOT TURN ON AT ANY SPEED,
WHETHER HIGH OR LOW (CONSOLE VERSION): troubleshooting procedure updated.
12.13 REVISION 3.5
Modication to paragraph §6.6.4 THE EFFORT LEVELS ARE SKIPPED - THEY DON'T
CHANGE CORRECTLY WHEN THE LEVER IS MOVED, OR THEY CHANGE
WITHOUT MOVING THE LEVER: troubleshooting procedure updated.
Modication to paragraph §6.6.5 THE EFFORT LEVEL DOESN'T CHANGE ON THE
DISPLAY: troubleshooting procedure updated.
Modication to paragraph §7.8.2 PIN ASSEMBLY: the tightening torque of the pin nut has been
altered.