Technogym Skillmill - 12.8 REVISION 3.0; 12.9 REVISION 3.1

Skillmill:
Technical Service Guide - Rev. 3.5
Page 131email: support@technogym.com
12.8 REVISION 3.0
New paragraph §6.6.4: EFFORT LEVELS SKIPPED - LEVELS DO NOT CHANGE CORRECTLY
WHEN THE LEVER IS MOVED - LEVELS CHANGE WITHOUT MOVING THE LEVER: new
troubleshooting procedure.
New paragraph §6.6.12: TREAD BELT NOT STRAIGHT/ NOISY BELT/ BELT DERAILMENT: new
troubleshooting procedure and instructions for adding clamps.
Change to paragraph §7.14 ANGLE SENSOR: details of procedure for removing and remounting
the angle sensor board.
Change to paragraph §3.1.2 DISPLAY (CONNECT VERSION): change to display function from the
latest SW version released.
Change to paragraph §7.9 TREAD BELT: details of procedure for removing and remounting a
single tread belt.
New paragraphs §6.3.5 DISPLAY CONFIGURATION, §6.3.6 TIME-OUT CONFIGURATION and
§6.3.7 SUMMARY CONFIGURATION: new commands added.
New paragraph §6.1 PROCEDURE FOR REPLACING COMPONENTS.
Change to paragraph §6.4.1.1 SCENARIO WITH SKILLMILL CONNECTED TO UNITY SELF
AND THE CLOUD: Unity Self conguration added (standardised procedure for all equipment).
New paragraph §3.2 TECHNICAL CHARACTERISTICS - SKILLMILL EUROPE AND USA
VERSION.
General revision §6 TROUBLESHOOTING AND CONFIGURATION.
General revision §7 REMOVING/REMOUNTING COMPONENTS, AND PRODUCT CHANGES.
General revision §3 OPERATING PRINCIPLE.
12.9 REVISION 3.1
Change to paragraph §6.7.1 SKILLMILL (CONSOLE AND CONNECT) CALIBRATION
PROCEDURE THAT DOES NOT ACTIVATE THE BACKLIGHTING OF THE KEYS
and §6.7.2 SKILLMILL (CONNECT) CALIBRATION PROCEDURE THAT ACTIVATES
THE BACKLIGHTING OF THE KEYS: addition of two important notes which must be taken
into consideration.
Change to paragraph §6.6.1:THE DISPLAY DOES NOT TURN ON (CONNECT VERSION).
New paragraph §6.6.9.1 USER CANNOT LOG IN - LOGIN ICON FLASHING (LOGIN
VIA QR CODE - TGS/NFC - BLUETOOTH): troubleshooting updated. Date/time check added.
New paragraph §6.3.8 DATE AND TIME CONFIGURATION: new date and time conguration
commands added.
New paragraph §6.8: PROCEDURE FOR SETTING THE DATE AND TIME.